EnjoyLED

how to make a handmade diy table lamp

Go to the flower market to select fine vines and soak them in a water basin until they can bend at will! Bend the soaked rattan into a ring, prepare another thick rattan, and six small rattan sticks, and pin the ends of the rattan sticks to the tip. Prepare a handmade washi paper, or use other tissue paper instead. A set of electric lights, and a small flower box. Glue the thick rattan to the flower box. Thread the wire. Punch a small hole in the flower box, and pass the wire through the hole. 

Glue the lamp head to the top of the thick rattan and make it into washi paper according to the size of the lamp umbrella. Put the rattan lamp umbrella on the outside of the paper tube, 

and glue the inside to the underside of the bulb and tie three small brackets made of disposable chopsticks. Glue the bamboo ring to the flower box and put small stones in it, so that it can strengthen ,Battery. 2. Production method 1. Cut out two cans respectively, and one of the bases must be left with a 10mm edge around it. 2. Cut a round hole with a diameter of 5 mm at the base of a base without leftover material, and then cut a 4×7 (mm) hole 10 mm away from the round hole.