EnjoyLED

How to install Pendant Light Fixture?the installation steps and methods of household chandeliers

How to install the chandelier properly? Let's first understand the structural combination of the lower chandelier. The bell, which is ceiling mounted on the ceiling, mainly supports the weight of the whole chandelier. It is generally made of metal, and the main consideration is the performance. Down is the hanging chain, which connects the lamp body to the middle part of the hanging bell. The center column is the whole center of the chandelier. When installing the chandelier, it is necessary to ensure the balance of the chandelier. Although there are few steps involved in the installation of the chandelier, its role can not be ignored. The lamp arm, lamp cup, lamp wick and lamp light are the embodiment of the beauty and practicability of the chandelier. They are generally complete sets. They are mainly installed according to the operating instructions. The installation method is not difficult at all. It is OK to strictly follow the instructions. The bottom support is at the bottom of the chandelier, playing a very good decorative effect. After understanding the structure of the chandelier, let's look at the general installation methods and steps of the chandelier in the household living room.

Step 1 of chandelier installation method

Make relevant preparations before the installation of the chandelier, including the determination of the installation position of the chandelier and the preparation of relevant tools and accessories. It is important to determine the position of the chandelier before installing the chandelier. Once the chandelier is installed, the position can not be moved, which will damage the ceiling. The approximate size shall be measured and the position shall be determined. If drilling is to be done on the ceiling, the drilling tools shall be prepared, including wood strips, plates, hardware accessories, screws, hammers, adhesives, etc.

Step 2 of chandelier installation method

Power on the drilling tools, drill holes on the gypsum board of the ceiling or ceiling according to the type of the bell, and then bury iron parts, hardware fittings or wood strips in the holes. The positions shall be accurate and there shall be some room for adjustment. Be sure to pay attention to the reserved position of the wires inside. After embedding, fill the periphery of the cavity with adhesive or cement slurry to increase its internal stress and load-bearing capacity. Wait until it is almost dry before the next step.

Step 3 of chandelier installation method

Connect and fix the connector in the bell with the embedded iron or wood strip, and add screws or other tools to make the connector firm and firm. Even when the chandelier is relatively large, it can be welded or mortised to make the bell firmly and tightly fixed with the ceiling. This is an important step in the installation of chandeliers. If this step is not fixed properly, the service life of chandeliers will be affected. Therefore, the load-bearing performance must be considered in place in this step.

Step 4 of chandelier installation method

The installation of the next chandelier is much simpler. The hanging chain or suspender penetrates from the bell. In fact, these installations are not complex. They are mainly installed step by step through the embedded parts of the chandelier according to the operation manual. The wires are introduced into the wick through the suspender. If the supporting lamp is equipped with a switch, When threading, you must pay attention to the control direction of the line.

Step 5 of chandelier installation method

The main supporting structures of the chandelier have been installed, and then the installation of the lampshade and lamp arm. It should not be difficult to install these according to the installation diagram. As long as the lampshade is assembled one by one with tools such as look, screwdriver and so on. After installation, power on and try the brightness. Adjust it according to the actual situation. In fact, the installation steps of chandeliers are not complicated. In fact, they are similar to the installation methods of ceiling lamps. During the installation process, some methods should be used properly. Of course, some matters should be paid attention to, such as the introduction of wires from the ceiling to the chandeliers. Attention must be paid to the details of installation to ensure the safety of switching on and off the chandeliers in the future, When multiple chandeliers are installed together, pay attention to the overall coordination and beauty, especially the height and size of the suspender.